Camera Sync
      Back to home
      1. Creamsource Knowledge Base
      2. Vortex
      3. Camera Sync

      Setting up Camera Syncing with Sync/Genlock Output using the Accessory BNC Cable

      Use the Creamsource Accessory BNC Cable (CSV-ACC-BNC) to setup cameras that are capable outputting a sync signal.

      1. Plug the Creamsource Accessory to BNC Cable directly into the BNC SYNC/AUX port of the camera.

      2. Plug the other end of the Creamsource Accessory to BNC Cable to the Accessory Input port of the Vortex. 

      3. Setup the camera to output the sync signal (refer to the user manual for device).

      4. Once sync is established, a green bar will be highlighted on the top of the status bar of the Vortex8 indicating the device is synchronised. The frame rate will also be displayed beneath the status bar.

      5. Calibrate the Vortex8 (see Calibrate Sync for details).